MICCROMASK STOP-OFF LACQUER 5 Gal Can

Purchase MICCROMASK STOP-OFF LACQUER 5 Gal Can

Maskants * Stop-off Lacquers * Plastisols * Masking Waxes * Masking Tapes * Lay Out Dyes

MICCROMASK is suitable for use in Hard Chrome Plating.

APPLICATION PROCEDURE

1. Chemically and/or mechanically clean the area of the part to be masked. The area to be masked must be free of all dirt, oil or other contaminants. Cleaning is the most critical aspect of the masking procedure.

Apply MICCROMASK to the area to be masked by dipping, brushing, or spraying. For application by spraying, reduce MICCROMASK by approximately 50% with MICCROMASK Reducer.

3. Apply a minimum of two coats depending upon the type of plating/chemical solution and/or length of processing time in solution. For heavy deposits of hard chrome, three or more coats of MICCROMASK are recommended. Allow at least 30 minutes air-dry time between coats and overnight air-dry time after application of final coat before introduction into solution. Faster drying of MICCROMASK can be accomplished. by force drying for 15 minutes in an oven not exceeding 1 50_F or over a hot plate not exceeding 1 50_F for 15 minutes. Drying time will vary according to relative humidity. NOTE: Make sure MICCROMASK has lost all solvent odor before force drying, applying additional coats, or placing over hot plate.

For fast, effective removal of MICCROMASK, use MICCROSTRIP A.

CHARACTERISTICS

Color: Light Red
Viscosity: 2200-2500 cps
Coverage Rate: Approx. 280 ft.2 (26 m2) per gallon,
2 mil dry film.

WtlGal.: 7.61 Ibs./gal.
Flash Point: 45_ F. TCC

MICCROMASK is available in: 1 gal., 5 gal., and 55 gal. containers.

REFER TO REVERSE SIDE FOR PRECAUTIONARY INFORMATION AND WARRANTY.

TOLBER DIVISION EMERGENCY PHONE NUMBER 1-800-264-2533 extension 2584

Developed and manufactured by experienced platers and coalers

PRECAUTIONARY INFORMATION

CONTAINS VOLATILE SOLVENTS _ Keep away from sparks and open flame. Store at temperatures above 32_ F and below 105_ F. Keep containers closed when not in use. Maintain adequate ventilation in working area. Wear approved respirators and protective clothingwhen working in confined areas. Avoid repeated breathing of concentrated vapors. Prolonged contact of liquid material with skin may be irritating. If material comes in contact with skin, wash skin surface thoroughly with soap and water. In case of eye contact, flush eyes thoroughly for 15 minutes with water and consult a physician. REFER TO MATERIAL SAFETY DATA SHEET FOR ADDITIONAL WARNINGS AND INFORMATION.

Purchase MICCROMASK STOP-OFF LACQUER 5 Gal Can